Cornelius Ice Maker DF150 User Manual

Ice Diverter ED/DF Dispensers Installation Instructions

INSTALLATION INSTRUCTIONS

ICE DIVERTER ED/DF DISPENSERS KIT P/N 02394

NOTE: For dispensing Scotsman NME654, NME954 and NME 1254 “Nugget” style ice and

Cornelius WCC500 and WCC700 “Chunklet” style ice cubes.

Disconnect power to dispenser.

Remove upper front panel/merchandiser from dispenser.

Remove ice chute portion and gate restrictor.

Install ice diverter as shown (see FIGURE 1) and reinstall the gate restrictor removed in previous

step. Gate restrictor should be installed in ‘front’ of ice diverter. It is critical the opening be set a

minimum of 1 ½” (see FIGURE 2).

STORAGE

HOPPER

GATE

MOUNTING

PLATE

FLANGE EXTENDS

INTO STORAGE

HOPPER THROUGH

GATE OPENING

ICE DIVERTER

P/N 15484

ICE CHUTE

APPLY RTV TO THIS

SURFACE TO SEAL TO

HOPPER GATE

MOUNTING PLATE

GASKET

FLAT WASHER

10-32 NUT

FIGURE 1. Exploded View of Ice Diverter Installation

FIGURE 2. Gate Restrictor with 1 ½” Opening

FIGURE 3. Timer Board Settings Reset

Remove screws securing white reflector panel and gain access to electrical box. Locate timer board

and reset agitation timer to 2 seconds ‘ON’ and 3 hours ‘OFF’ (see FIGURE 3).

Re-install front panel and plug unit back into outlet.

Unit should now be ready to dispense ice for customer use.

Revision Date: June 2, 2005

Revision: C

- 1 -

Publication Number: 92303INS