Extron electronic Projector Accessories PMK 155 User Manual

PMK 155 • Installation Guide

The Extron^®PMK 155 Pole Mount Kit is a simple solution for mounting Extron devices and

their external power supplies to a projector pole. The PMK can be installed on a 1.5-inch

pipe within a 4-inch space between the projector and the ceiling.

Including the power supply, the following devices can be mounted:

one three-inch deep half-rack device, or

one six-inch deep half-rack device, or

two three-inch deep quarter rack devices,

Mounting Plate

Pipe Clamp

an MPA 401

ATTENTION: The maximum load for the

(2) Hex Bolts

PMK 155 is 5 lbs (2.25 kg).

(2) Washers

(2) Tie Wraps

NOTE: The PMK 155 is to be used only

with Extron UL listed products.

Installation

NOTE: Ensure the ﬁnished installation is in accordance with local and national buildng

codes, ﬁre and safety codes, UL requirements, and local and national electrical

codes.

To install the PMK 155 (with a device) on a projector pole:

1. Place the plate on the base of the device and align holes in the plate with the

mounting holes in the device.

Use 2 mounting holes on

opposite corners.

(2) 4-40 x 3/16"

Screws

2. Secure the device to the plate with 4-40 screws.

ATTENTION: Use only the screws supplied with the device to avoid damaging it.